







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Westchester, FL: Scope, Timeline, and Cost
Asphalt Driveways & Resurfacing in Westchester, FL, typically runs $3,500 – $9,000 for a new asphalt pave and $250 – $700 for a reseal, with most residential jobs finished in 2 – 4 days once the base is prepped. The work means grading and compacting the sub-base, laying 2 – 3 inches of hot-mix asphalt in lifts, rolling it while it’s still hot, and sealing it after a curing window. Call (833) 630-4214 and we’ll walk your driveway, measure it, and put the number in writing.
How the job actually runs, from demolition to the first seal coat

Asphalt isn’t a pour-and-go material. The base does most of the work, and in Westchester’s sandy, high-water-table soils that means we spend more time under the surface than on top of it. Here’s the sequence we follow on nearly every residential drive here.
Stage 1 – Site walk and layout (day of estimate). We measure the drive, check the slope away from the garage and street, probe the existing base, and look for where water is pooling after rain. This is where you decide width (a single 10-foot lane versus a 16-foot double), whether to add a turnaround apron, and whether you want a gravel shoulder or a flush concrete transition at the street. Decisions here set the price; changing width later means re-pricing the whole job.
Stage 2 – Demo and excavation (day 1). Old asphalt, cracked concrete, or sod comes out, and we excavate down 6 – 8 inches to reach stable material. On the older 1960s-80s lots common in Westchester we sometimes hit buried debris or old tree roots that have to be cleared before the base goes in. Expect a full day, sometimes two on a long drive.
Stage 3 – Base and grading (day 2). We lay and compact a crushed-stone base in lifts, wetting and rolling each lift so it locks. Then we cut the grade so water sheets off the drive and away from the slab. This is the stage that separates a driveway that lasts 20 years from one that ruts in three, and it’s why we don’t quote asphalt over an unprepared base.
Stage 4 – Hot-mix paving and rolling (day 3). Asphalt arrives hot and gets laid in 2 – 3 inch lifts, then rolled while it’s workable. The edges get tamped, and we check the grade again before it cools. On a typical Westchester drive this is a single day. You can’t drive on it for 24 – 48 hours, and we tell you the exact window before we start.
Stage 5 – Cure and seal (3-12 months later). Fresh asphalt needs to cure and off-gas before sealing, usually somewhere between three months and a year depending on weather. Sealing too early traps oils and softens the surface. We schedule the seal coat as a separate visit, and that’s the step that keeps a Westchester drive from drying out and cracking under the summer sun.
Total elapsed time from demo to drivable surface is usually 3 – 4 working days. The homeowner’s real decisions are width, base depth on soft spots, and the seal timing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices that actually change the finished drive
Asphalt is one material, but there’s a lot of room inside that. Here’s what we walk through with you.
- Hot-mix asphalt thickness. 2 inches is a light-duty residential lay for a car-only drive; 3 inches handles trucks, trailers, and heavier traffic. Going thinner saves a few hundred dollars and costs you in rutting within a few seasons.
- Base depth and stone grade. A 4-inch compacted base is the minimum on firm soil; Westchester’s sandy spots often call for 6 inches with a geotextile fabric underneath to keep stone from migrating. Fabric adds cost but stops the sinking.
- Seal coat timing and type. Coal-tar-free asphalt emulsion is the standard and what we use; a sand-slurry seal covers fine cracking and gives a smoother finish. Sealing every 3 – 4 years in this climate keeps the surface from oxidizing.
- Edge restraint. A concrete curb or compacted stone shoulder holds the asphalt edge. Without it, edges ravel and the drive narrows year by year.
- Drainage detailing. A trench drain, a swale, or a simple grade crown all work; the honest trade-off is that a trench drain handles heavy rain better but needs cleaning, while a crown is free but limited on flat lots.
If you’re pairing the drive with a full hardscape plan, our Driveway & Pavers service covers the paver and concrete side, and Tremron and Oldcastle products show up naturally on jobs where a homeowner wants an asphalt drive with a paver apron or border.
What Asphalt Driveways & Resurfacing costs in Westchester, FL

Expect $3,500 – $9,000 for a new asphalt drive and $250 – $700 for a reseal on a typical single-family lot in Westchester. The range is wide because size, base condition, and drainage do most of the moving.
| Line item | Westchester range |
|---|---|
| New asphalt paving (per job) | $3,500 – $9,000 |
| Full driveway replacement (demo + new) | $5,000 – $14,000 |
| Seal coat (per job) | $250 – $700 |
The variables that push a job to the high end:
- Square footage. A 20×20 single-car drive sits near the bottom; a 24×40 double with a turnaround climbs toward the top.
- Existing base condition. Soft or buried-debris base means excavation and extra stone, which adds cost fast.
- Drainage work. Adding a trench drain or re-grading a flat lot adds real money.
- Access and demo. Tight side yards and old concrete to break out cost more than a clean grassy lot.
- County permit scope. Most residential re-paves don’t need a permit, but new drive approaches that touch the right-of-way do.
Every written estimate from us is line-itemed: excavation, base, asphalt tonnage, edge restraint, and any drainage, with the number you see being the number you pay. What’s not included – like a future seal coat – gets listed separately so there’s no surprise later. If the whole project is bigger, like a drive plus a patio and walkway, it becomes part of a full Driveway & Pavers in Westchester plan.
See the difference
Before
After
Before
After
Before
AfterWhat Westchester homes do to this job specifically
Westchester is an unincorporated pocket of Miami-Dade, which means there’s no local city hall issuing driveway permits. Anything that touches the right-of-way – a new approach or a widened curb cut – goes through Miami-Dade County e-permitting, and the county’s High-Velocity Hurricane Zone rules shape how the drive ties into the structure, especially flashing and drainage where the drive meets the garage slab. We work with that process routinely.
The housing stock does the rest. The 1960s-80s concrete-block ranch and Mediterranean homes across Westchester often have original concrete or settled asphalt drives that drain toward the garage, and the heavy summer rains show it. On infill lots where a new two-story has replaced an older ranch, we’re usually re-grading the whole apron to match the new slope. We cover Westchester including the blocks near the main corridors and down into the quieter residential streets, and the failure modes we see most are edge raveling, alligator cracking from a thin base, and rutting where a drive has no real shoulder. Homeowners often pair an asphalt drive with a Chain Link Fence in Westchester to define the property line, or with ADU Site Prep & Utilities in Westchester when they’re adding a unit and need the drive extended to reach it.
Serving Westchester, FL – Our Local Coverage Area
We serve Westchester and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Asphalt Driveways & Resurfacing in Westchester

Most residential jobs take 2 – 4 working days, plus a 24 – 48 hour no-drive cure window before you park on it. Demo and base prep eat most of that time; the actual paving is usually a single day.
Usually not for re-paving an existing drive, but a new or widened drive approach that touches the county right-of-way requires a Miami-Dade County permit through e-permitting. We handle that process as part of the job.
Sometimes yes. A 1.5-inch overlay works when the base is sound and the existing surface has only surface-level cracking. If there’s alligator cracking or a soft base, we recommend a full replacement instead, because an overlay over a failing base just fails faster.
$250 – $700 for a typical residential drive, done 3 – 12 months after new paving and then every 3 – 4 years. Call (833) 630-4214 and we’ll quote the seal separately from the pave.
Every job is backed by our 730-Day Done Right Promise – if it’s not done right, we make it right. That covers the workmanship on grading, base, and paving.
Get a written estimate for Asphalt Driveways & Resurfacing in Westchester
Call (833) 630-4214 for a free on-site estimate. A live person answers, day or night. We’ll walk the drive, check the base and drainage, and hand you a line-item quote with the actual square footage, tonnage, and any county permit work spelled out. No change orders, no vague ranges – the number you see is the number you pay, backed by the 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












