







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Cabinets & Countertops in Brownsville, FL: What the Job Actually Involves
Cabinets & countertops in Brownsville typically run $14,000 – $45,000 for a full kitchen’s worth of new cabinetry and stone, and the work takes four to seven working days once materials land on site. That number covers tear-out, cabinet set and level, countertop template and install, and the finish trim. Smaller scopes land lower: cabinet installation alone runs $4,000 – $13,000, countertop installation $2,000 – $6,500, and a backsplash $800 – $2,500. Call (833) 630-4214 and we’ll walk your kitchen and put real numbers on paper.
How we run a cabinet and countertop job, start to finish

Most of the schedule risk in this trade happens before anyone touches a screwdriver. Here’s the sequence we hold to on Brownsville jobs.
Stage 1: Walk-through and field measurement (day 1, about 90 minutes). We measure the actual walls, not the drawing. Mid-century concrete-block homes in Brownsville are rarely square, and a wall that reads 120 inches on a tape can be 119¼ at the base and 120¾ at the header. You decide the cabinet layout and door style at this visit, because those choices drive lead time.
Stage 2: Written scope and material order (days 2 – 5). You get a line-item estimate: cabinet boxes, doors and drawer fronts, hardware, countertop material and edge, sink cutout, disposal of old units. Once you approve, cabinets get ordered. Stock lines run one to two weeks; semi-custom runs three to five. This is the longest wait of the project and the one homeowners underestimate.
Stage 3: Demo and prep (day 1 on site). Old cabinets and countertops come out, usually in a single morning. We check the wall behind them for water staining, soft drywall, or rusted framing straps, and we check that the shutoffs and outlets are where the new layout needs them. If a circuit has to move or a supply line has to be reworked, that’s a decision point for you and it changes the price.
Stage 4: Cabinet set and level (days 2 – 3). Base cabinets first, shimmed and screwed to the studs, then uppers. Crown, light rail, and filler strips get fit. Doors and drawers go on and get adjusted. You walk it and confirm hardware placement before the countertop template.
Stage 5: Template, fabrication, install (days 3 – 7). Stone gets templated on site after the cabinets are set, fabricated off site, then installed. Sink and faucet set at the same visit. You get the final walkthrough after caulk and touch-up, and the job closes out with the 730-Day Done Right Promise in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The choices you’ll be making, and what each one really costs you
Cabinet and countertop selection is where budgets quietly drift. These are the trade-offs we walk through with Brownsville homeowners most often.
- Stock vs. semi-custom cabinets. Stock boxes are cheaper and arrive in one to two weeks, but you’re limited to fixed widths and filler strips to close gaps. Semi-custom lets you dial in widths for an odd wall and adds two to three weeks and meaningfully more cost. In older Brownsville homes with out-of-square walls, semi-custom often pays for itself in how the finished run looks.
- Plywood vs. particleboard boxes. Plywood holds up better to South Florida humidity and to the occasional under-sink leak. Particleboard is fine in a dry, well-vented kitchen and saves money.
- Quartz vs. granite vs. laminate. Quartz is non-porous and needs no sealing, which suits a humid climate. Granite is durable but wants resealing roughly once a year. Laminate is the budget option and can look sharp, but seams and heat are its weak points.
- Edge profile and thickness. A standard eased edge in 3cm stone keeps fabrication simple. Bullnose, waterfall, and mitered edges add fabrication time and cost.
- Door style and finish. Painted shaker and slab fronts are the two we install most. Painted finishes show chips at the corners sooner than a thermofoil or laminate front, but they can be touched up.
We work with KraftMaid cabinetry and Cambria quartz among other lines, so you’re choosing between verified products rather than whatever a supplier happens to have in stock.
What cabinets and countertops cost in Brownsville, FL

Plan on $14,000 – $45,000 for a full kitchen’s cabinetry and countertops, with the low end being a compact galley with stock cabinets and a modest stone, and the high end being a large kitchen with semi-custom cabinetry, premium quartz, an island, and relocated plumbing or electrical.
Five things push the number:
- Linear footage and cabinet count. More boxes, more drawers, more cost. A 10-foot run and a 30-foot run aren’t the same project.
- Existing condition. Water damage, out-of-square walls, or a floor that needs leveling before cabinets go in adds labor.
- Moving plumbing or electrical. Relocating a sink, adding a dedicated circuit for a range, or moving a disposal switch is a real cost, and it needs to be quoted up front, not discovered mid-job.
- Material grade. Stock vs. semi-custom cabinetry and laminate vs. quartz is the single largest swing in the estimate.
- Permit scope. Cosmetic cabinet swaps in unincorporated Miami-Dade usually don’t require a permit; moving plumbing, gas, or structural walls typically does. We tell you which category your job falls into before we quote.
A written estimate from us includes tear-out, disposal, cabinet and countertop material, labor, hardware, sink cutout, and final caulk and touch-up. It does not include appliance purchase or a full backsplash unless you add it. Upfront pricing, no surprises: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhat Brownsville homes specifically do to this job
Brownsville is unincorporated Miami-Dade, west of Liberty City, ZIP 33142, and that one fact changes the permitting reality on every cabinet and countertop job here. There’s no city building department to call. Plans and permits go through Miami-Dade County, and inspection scheduling runs on the county’s calendar, not ours. When a permit is required, plan for extra days between stages, and expect the county to kick plans back over missing wind-mitigation and product-approval documentation (NOA/HVHZ) rather than over design. That’s a paperwork quirk crews working this neighborhood learn fast.
The housing stock matters just as much. Most of what we open up in Brownsville is mid-century single-family: 1940s – 1970s concrete block and wood-frame homes with flat or low-pitch roofs, carports, and add-on rooms or converted garages. Kitchens in these homes were often reworked once already, sometimes without a permit, so we check for undersized circuits, shutoffs in the wrong place, and out-of-square walls before we order a single cabinet. If the kitchen is part of something bigger, this often ties into Kitchen Remodeling in Brownsville, and we cover the full scope through our Kitchen Remodeling service if you want one contractor for the whole project. We also see homeowners pair new cabinetry with a Garage Conversion ADU in Brownsville or a New Detached ADU in Brownsville, since both bring a second kitchen into the plan. We serve the whole Brownsville area, and technicians with up to 12 years of experience handle the work, background-checked and in uniform.
Serving Brownsville, FL – Our Local Coverage Area
We serve Brownsville and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: cabinets and countertops in Brownsville

Most Brownsville projects finish in four to seven working days on site, but the total calendar time is longer because cabinets must be ordered and stone must be templated after the cabinets are set. Stock cabinets add one to two weeks of lead time; semi-custom adds three to five. Call (833) 630-4214 for a realistic schedule based on your kitchen.
Usually not if it’s a like-for-like swap in the same footprint. A permit typically enters the picture when you move plumbing, move gas, add a circuit, or change structure. Because Brownsville is unincorporated, any permit runs through Miami-Dade County, not a municipal building department, and the county asks for wind-mitigation and product-approval documentation on the plans. We’ll tell you which category your job lands in before we quote.
Yes, and it’s the most common version of this job. Keeping the sink where it is and staying within the existing footprint avoids a permit and shortens the timeline considerably. If your layout is genuinely cramped, we’ll show you what relocating the sink or range would add to the cost, and you decide from there.
Cabinet installation in Brownsville runs $4,000 – $13,000, countertop installation runs $2,000 – $6,500, and a full kitchen’s worth of both runs $14,000 – $45,000. Where you land depends on linear footage, stock vs. semi-custom, and whether plumbing or electrical has to move. Call (833) 630-4214 for an exact quote – estimates are free.
Every cabinet and countertop project we install is covered by the 730-Day Done Right Promise. If something isn’t right, we make it right, and the terms are in writing before work starts. Product warranties from the cabinet and stone manufacturers apply separately.
Get a free estimate on cabinets and countertops in Brownsville
We’ll come out, measure the actual walls, and hand you a line-item estimate that breaks out materials, labor, and permit scope. No-hassle upfront pricing, and the estimate and design consult are free. Call (833) 630-4214. A live person answers around the clock, so you won’t hit voicemail. If your project qualifies, there’s $1,000 off projects over $10,000 and 0% financing for 18 months available.
Written by the team at Groundwork Construction Co.












