







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Coral Gables, FL: What the Job Actually Involves
Door installation in Coral Gables, FL typically runs $1,200 to $4,800 per exterior door, with impact-rated wind-load doors landing at the high end and interior door swaps near the low end. A single pre-hung exterior door is usually a one-day install; a full entry system with sidelights, transom and impact glazing runs two to three days. For an exact number on your opening, call (833) 630-4214. Estimates are free, and we write them line by line so nothing moves later.
How We Run a Door Installation, Stage by Stage

Door work looks simple until you open a 1920s Coral Gables wall and find coral rock, three decades of paint, and a frame that’s been shimmed four times. Here’s the sequence we work through, and where you’ll be making the call.
Stage 1: Measure and Site Visit (Day 1)
We measure the rough opening, check the frame for plumb and square, and note the wall assembly – stucco over coral rock, stucco over block, or wood framing, depending on the era of the house. You decide here whether we’re replacing the door in the existing frame or cutting back to the rough opening. That one choice drives most of the price and the schedule. We also confirm whether design review is triggered.
Stage 2: Product Selection and Wind-Rating Review (Days 2-10)
You pick the door system – impact-rated fiberglass, impact-rated wood, aluminum, steel – and we confirm the product’s High-Velocity Hurricane Zone (HVHZ) approval and its design pressure rating against the opening’s wind-load requirement. In Coral Gables, this isn’t optional paperwork; it’s the first thing the inspector asks for. Approvals and lead times can sit 2-6 weeks depending on the manufacturer, so this is the longest pre-construction stretch.
Stage 3: Permits and Design Approval (Weeks 1-8)
Most exterior door replacements in Coral Gables require a building permit, and exterior changes in the historic districts or on properties under the city’s design review get routed to the Board of Architects for approval before a permit is issued. We prepare the submittal, coordinate the product approvals, and factor in board meeting schedules. This is the part that catches out-of-town contractors; a door swap that takes a day to install can take a month or two to approve.
Stage 4: Demo, Prep, and Install (Day 1 of Construction)
We protect the interior, remove the old door and frame, and inspect the opening for rot, termite damage, or a cracked lintel. Stucco is cut back cleanly for a proper flashing tie-in. The new door goes in plumb and square, shimmed at the hinge and strike sides, with pan flashing and a sill pan set beneath it. A standard pre-hung exterior door is one long day. Entry systems with sidelights and a transom take two to three days.
Stage 5: Sealing, Hardware, and Inspection (Days 2-3)
We seal the perimeter with a compatible sealant and backer, finish the stucco patch or trim detail to match the house, hang hardware, and set the strike plates and deadbolt. Then we call for the final inspection and hand you the signed-off permit and the product approval documentation. You’ll want that paperwork for insurance and for any future sale.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
For most Coral Gables homes, the decision comes down to door material, impact rating, and how the door reads against the architecture. Here’s the honest trade-off on each.
- Impact-rated fiberglass: The most common choice on Coral Gables exteriors. It takes paint and stain beautifully, mimics wood grain, and the cost runs about $1,800-$3,800 per installed door. It won’t rot like wood or dent like steel, and it holds up to South Florida humidity better than almost anything else.
- Impact-rated wood (mahogany, oak): The right look for Mediterranean Revival homes. Expect $3,000-$6,500 installed. Beautiful, heavier to operate, and it needs periodic refinishing or the humidity will find the seams. Suits homeowners who’ll maintain it.
- Aluminum: Light, corrosion-resistant, and well-suited to mid-century ranches. Typically $1,500-$3,200 installed. Less visual warmth than wood but lower maintenance. We reach for it on clean-lined homes.
- Steel: Security and clean lines at $2,000-$4,500 installed. Dents, and needs an anti-corrosion finish. Rarely the right fit for a Gables style home, but it works on service and security doors.
- Impact glazing vs. shutter-protected: Impact glass carries a higher door cost but eliminates the shutter routine before every named storm. If you’re already planning to make the whole envelope storm-ready, this often pairs naturally into a full Windows & Doors in Coral Gables scope.
- Hardware and finish: Bronze, brass, matte black, or a satin nickel. Wrought-iron-style hardware and Mediterranean pulls read correctly on a Coral Gables façade. The right hardware adds $150-$600 and is worth the spend.
What Door Installation Costs in Coral Gables, FL

Plan on $1,200 to $4,800 per exterior door, and $400 to $1,400 for interior door installation. A full entry system with sidelights and transom runs $3,500 to $8,000 depending on the material and impact rating. Here are the variables that push a job to the high end.
| Line Item | Typical Range |
|---|---|
| Interior door installation (per door) | $400-$1,400 |
| Standard exterior door installation | $1,200-$2,600 |
| Impact-rated exterior door | $1,800-$4,800 |
| Entry system with sidelights/transom | $3,500-$8,000 |
| HVHZ product approvals & permitting | Included in quote |
What moves the number:
- Opening size and configuration: Standard 3’0″ x 6’8″ is the baseline. Sidelights, a transom, or a widened opening with a new header add $800-$2,500 in framing and finish work.
- Existing condition: Rot, termite damage, a cracked lintel, or an out-of-square frame adds $300-$1,200 in repair before the door goes in. Uncovered in demo, we flag it and price the fix in writing before we proceed.
- Material grade: Fiberglass at the low end, wood at the top. The spread is real and reflects maintenance, weight, and finish quality.
- Design review scope: Historic-district properties on the Board of Architects path add approval time and, occasionally, a required style detail to match the streetscape.
- Permit scope: A one-for-one replacement is a smaller permit than a resized opening or a system adding new structural support.
Every quote we write is line-itemed and fixed. The number you see is the number you pay, and our 730-Day Done Right Promise stands behind the workmanship for two full years.
See the difference
Before
After
Before
After
Before
AfterWhat Coral Gables Homes Specifically Do to a Door Installation
Coral Gables is a planned Mediterranean Revival city, and it carries one of the strictest historic-preservation and design-review regimes in the country. That means an exterior door change isn’t just a construction call; it’s a design-compliance exercise. On properties in the locally designated historic districts, or on homes under city design review, the Board of Architects reviews the proposed door, its glazing, its finish, and its compatibility with the surrounding architecture before a permit is issued. Our submittals typically include photos, product cut sheets, and the HVHZ approval – all assembled and coordinated for the meeting schedule.
The housing stock makes this a live question on nearly every Gables street. Homes from George Merrick’s original 1920s plan run on coral rock and stucco walls with clay barrel tile roofs, so a door swap has to reconcile with the surrounding finishes – the stucco texture, the trim profile, the wrought-iron detailing. Mid-century ranches and newer infill sit right alongside, and each era plays by slightly different rules. We routinely see this on homes around the Granada Boulevard corridor and near the Riviera neighborhood.
South Florida’s hurricane zone means the door has to meet high-wind HVHZ product approvals, and the humidity means the seal and flashing detailing has to be right the first time. This isn’t a category where shortcuts get forgiven; water finds the weakest seam. Live oaks and banyans also shape the work – the city’s tree-protection ordinances can block equipment access, and roots heave the way a door’s threshold sits.
When the job pairs with a broader project, our Windows & Doors service and our Coral Gables coverage team connect the work cleanly. Homeowners often pair door replacement with Cabinets & Countertops in Coral Gables during a full interior refresh, or with a Garage Conversion ADU in Coral Gables when a new entry is part of an added unit.
Serving Coral Gables, FL – Our Local Coverage Area
We serve Coral Gables and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Coral Gables

A single pre-hung exterior door is typically a one-day install, while an entry system with sidelights and a transom takes two to three days. Interior doors run 2-4 hours each and we often batch several in a single visit. The permit and design-review timeline runs separately and can add 3-8 weeks; we factor it into the schedule up front. Call (833) 630-4214 to book a measurement visit.
Most exterior door replacements in Coral Gables require a building permit, and exterior changes in the historic districts or under city design review also go before the Board of Architects. Interior door swaps generally do not require a permit unless you’re changing the opening structure. We pull the permits and handle the submittal; you get the signed-off permit and the HVHZ product approvals in hand when the job is done.
Yes, in most cases. A one-for-one exterior door replacement uses the existing rough opening and doesn’t touch plumbing or structure. Widening the opening or adding a transom requires a new header and framing, which changes the scope and permit. We confirm the approach during the initial measurement visit so there are no surprises once demo starts.
Interior door installation runs $400-$1,400 per door, and exterior doors run $1,200-$4,800 per door, with impact-rated entry systems landing at $3,500-$8,000. The variables are size, material, existing frame condition, and whether design review applies. Call (833) 630-4214 for an exact quote on your opening – estimates are free and line-itemed.
Every door installation we complete is covered by our 730-Day Done Right Promise for workmanship, in addition to the manufacturer’s product warranty. If something isn’t right, we make it right. Keep the product approval documentation we hand over; your insurance carrier and a future buyer will both want to see it.
Get a Free Door Installation Estimate in Coral Gables
Call (833) 630-4214 to schedule a free on-site estimate for door installation in Coral Gables. A live person answers, day or night, and we’ll set a measurement visit around your schedule. On that visit we measure the opening, check the frame and wall assembly, and walk you through the color, hardware, and impact-rated options that fit a Coral Gables home. You’ll get a written, line-itemed quote with the permit and design-review path spelled out, and no obligation to move forward. Upfront pricing, no surprises.
Written by the team at Groundwork Construction Co.












