







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door installation in Gladeview: what the job actually involves
Door Installation in Gladeview, FL usually runs $450 to $2,800 per opening for an exterior or interior door, and a typical replacement is a one- to two-day job once the door is on site. Exterior doors built to Miami-Dade’s High-Velocity Hurricane Zone standards cost more than the same door in most of the country, because the product itself is tested and rated for 150+ mph wind pressures. Call (833) 630-4214 for a free on-site estimate with a line-item price.
How a Gladeview door installation actually runs, day by day

We sequence every door job the same way because skipping a stage is how doors end up sticking in July. Here’s what happens from first call to final walkthrough.
Stage 1: Measure and product selection (day 0)
We measure the rough opening, note the wall depth on your CBS block, and check which direction the door swings and whether the hinge side can change. This is where you decide the door type, material, finish, and whether you want glass or solid. On an exterior door in Gladeview, this is also where we confirm the product carries the correct Miami-Dade NOA or Florida Product Approval, because an unrated door won’t pass inspection. Expect this walkthrough to take 45 to 90 minutes.
Stage 2: Ordering and lead time (1 to 4 weeks)
Standard steel and fiberglass doors arrive in 7 to 14 days. Custom sizes, wood doors, and hurricane-rated units with impact glass can take 3 to 6 weeks. We give you the order date and the install date in writing so you’re not guessing. Interior doors are typically the short end; exterior impact-rated doors run longer.
Stage 3: Protection and demo (2 to 4 hours)
We lay drop cloths and mask adjacent surfaces, then pull the old door, frame, and trim. On older Gladeview CBS homes, this stage usually reveals what the original install hid: rotted jamb bottoms, termite damage behind the frame, or a rough opening that’s out of square. We photograph it and show you before anything is covered up. If there’s structural damage, that’s the one point where we stop and quote the repair before continuing.
Stage 4: Framing, flashing, and setting the door (3 to 6 hours)
We square and shim the frame, set the door, and flash the rough opening. In Gladeview, flashing and sealant work matter more than in a dry climate because wind-driven summer rain finds every gap. We use a sill pan and backer rod under the threshold, and we seal the perimeter in a way that lets water drain rather than trapping it behind the trim.
Stage 5: Hardware, trim, and final test (2 to 3 hours)
We hang the door, install the lockset and deadbolt, add the trim, and test the swing. The door should close against the weatherstripping with even pressure all around and latch without a shove. We adjust hinges and strike plates until it does. Inspection, where required, comes after this.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The door choices you’ll weigh, and what each one costs you
Every door is a trade-off between price, weather resistance, and how it holds up under Miami-Dade sun. Here’s what we actually put in Gladeview homes.
- Steel exterior doors: the most common choice for front and side entries at $450 to $1,200 installed. Durable, paintable, and easy to rate for impact. The downside is that steel dents and can rust at the bottom edge if the threshold isn’t sealed correctly, so the install details matter as much as the door.
- Fiberglass exterior doors: $800 to $2,000 installed. Fiberglass handles humidity better than steel and won’t dent. It costs more, and the finish can chalk over years in direct Florida sun unless it’s a UV-stable finish.
- Impact-rated glass doors: $1,500 to $2,800 installed. These carry the Florida Product Approval you need for a permit on an exterior opening in the HVHZ. If you’re replacing an exterior door that opens onto a patio, this is the right call and it’s also where our Windows & Doors in Gladeview scope often overlaps.
- Solid wood doors: $600 to $1,800 installed. Beautiful, but on Gladeview’s humidity, solid wood moves and swells. We use them where the door sits under a deep overhang or in climate-controlled interior locations.
- Interior hollow-core vs. solid-core: hollow-core runs $250 to $550 installed and suits closets and bedrooms; solid-core runs $400 to $900 and gives better sound control between rooms.
We work with Andersen and Marvin on the exterior doors where a name-brand, hurricane-rated product matters to you.
What door installation costs in Gladeview, FL

Most Gladeview door installations land between $450 for a basic interior door and $2,800 for a full impact-rated exterior entry. A whole-house interior door replacement typically runs $3,000 to $8,000 for 8 to 12 doors, and an exterior entry set with sidelights runs $2,000 to $4,500.
Here’s what pushes a job toward the high end:
- Door type and rating: an unrated interior door is the low end; an impact-rated exterior door with glass is the top.
- Frame and rough opening condition: a clean opening installs fast. Rotted jambs, out-of-square framing, or a wall that needs repair adds $300 to $900.
- Size: standard 32- or 36-inch doors are cheapest. Oversized, double, or custom-size doors cost 20 to 40 percent more.
- Relocation: moving a door to a new wall, or widening an opening, means framing work and possibly a header, which adds $700 to $2,500.
- Permit scope: an exterior door in the HVHZ needs a permit; interior door swaps usually don’t.
Your written estimate lists the door, hardware, trim, labor, permit fees where required, and disposal of the old door. It won’t list unexpected structural repair, which we quote separately only after you see the photos. Upfront pricing means the number in the estimate is the number you pay for the scope we describe, backed by our 730-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterWhat Gladeview homes specifically do to a door job
Gladeview is unincorporated Miami-Dade County (ZIP 33147), which means nearly all construction here runs through Miami-Dade County permitting and the Florida Building Code’s High-Velocity Hurricane Zone rules. For an exterior door, that means the product has to carry a valid Miami-Dade NOA or Florida Product Approval, and the shutter or opening protection has to be documented in the permit package. It’s a heavier paper trail than a homeowner expects, and it’s why we handle the submittal as part of the job.
The housing stock shapes the work too. Gladeview’s mid-century CBS block homes and small duplexes often have original jamb framing that’s been softened by decades of subtropical humidity and heavy summer rain. We regularly find rotted sill plates and termite-damaged studs once the old door comes out, and we don’t hide it behind new trim. If you’re working on an exterior entry near the big-box corridor along NW 79th Street, expect the opening dimensions to be slightly off standard, since original block construction rarely came in at nominal size.
And the hurricane history matters: post-Andrew rebuild standards are baked into everything here now. For most of what we install, the door rating is the inspection hinge. Homeowners often pair a door replacement with a larger plan, and this is where our Windows & Doors service and the wider Gladeview coverage come in, along with work we do on Cabinets & Countertops in Gladeview and Garage Conversion ADU in Gladeview.
Serving Gladeview, FL – Our Local Coverage Area
We serve Gladeview and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: door installation in Gladeview

A single door takes one to two days on site, plus one to four weeks of lead time for the door itself. Interior door swaps are usually the one-day end; an exterior impact-rated entry with framing work runs the longer end. We put both dates in writing before you commit.
Exterior door replacements in Gladeview need a Miami-Dade County permit because they’re in the HVHZ and the door must be a rated product. Interior door swaps generally don’t require one. We pull the permit, submit the product approval, and schedule the inspection as part of the job.
Yes, in most cases. A straight replacement reuses the existing rough opening and doesn’t touch plumbing or framing beyond shimming. The exceptions are widening an opening, relocating a door, or repairing hidden rot, which we quote before we touch the wall.
Most jobs land between $450 and $2,800 per door, with a whole-house interior swap in the $3,000 to $8,000 range. Impact-rated exterior entries sit at the top of the per-door range. Call (833) 630-4214 for an exact quote; the on-site estimate is free.
Every door we install is covered by the 730-Day Done Right Promise, which runs two full years and covers our installation work. If a door we hung doesn’t close, seal, or latch the way it should, we come back and make it right. Manufacturer coverage on the door itself is separate and we walk you through it.
Get a free door installation estimate in Gladeview
Call (833) 630-4214 to schedule your free on-site estimate for door installation in Gladeview. We’ll measure the openings, show you the product options with real prices, and hand you a written line-item quote with the permit scope spelled out. No pressure, no vague bids, just the number and the plan. If you’re planning the door as part of a bigger project, ask about $1,000 off projects over $10,000 and 0% financing for 18 months.
Written by the team at Groundwork Construction Co.












